A washer stopping mid-programme isn't one single fault; it stops when a condition for the next stage fails: filling, heating, draining or balance.
Possible causes
- Drain failure before rinse or spin
- Low water pressure during rinse
- Water not reaching the target temperature
- Voltage fluctuation
- Door lock losing contact mid-cycle
- Control board fault
Safe first checks you can do
Safety: unplug the appliance and close the water tap before any check, and never open the outer casing or electronic boards yourself.
- Note any error code and the stage where it stopped
- Clean the pump filter and check the tap
- Make sure it isn't sharing an extension with other appliances
Related parts
Door lockDrain pumpLevel sensorControl board
When do you need a technician?
Knowing the stage where it stopped shortens diagnosis a lot; send it with the model number when you book.
Frequently asked questions
Should I switch it off and on again?
Once, after a few minutes, is fine; if it keeps stopping, don't keep retrying.
Related problems
Beko washer door won't open or lockBeko washer won't start the programmeBeko washer keeps filling with waterEError codes – Washers